Every decision buried in the ground surfaces years later.
Geomembranes, geosynthetic clay liners, geotextiles, geocells and drainage composites — every product group a site may need, under one roof, with a single technical counterpart.
“Buying a geosynthetic product is, in truth, buying an engineering decision.”
One roof, one technical counterpart.
Buying a geosynthetic product is, in truth, buying an engineering decision. A defect in the material that must perform inside a dam embankment, behind a tunnel or at the base of a waste site reveals itself years later — which is why, in this business, there is no such thing as “good enough”.
We bring together, under one roof, the full range of product groups a site may need: geomembranes, geosynthetic clay liners, geotextiles, geocells and drainage composites. For a project manager, this means working with a single technical counterpart for separation, filtration, drainage, sealing and erosion control alike.
Before it leaves for site, every one of our products is tested to the relevant ASTM, EN or GRI standard; the results are verified both in our own laboratory and by independent bodies, and shared with every customer who requests them. Before we call a product “durable”, we know to which standard and with which test result it is durable — and when we do not know a technical detail, we do not guess; we say so.
Five solution families.
Separation, filtration, drainage, sealing and erosion control — every layer a site may need.
Lining & Sealing
The barrier layer that keeps water, leachate and chemicals where they belong. The geomembrane family and the active clay liner.
4 products
Drainage
A three-dimensional net that carries away the liquid and gas collecting above the barrier — in-plane, without raising the section.
1 products
Separation & Filtration
The geotextile family: separating two soils without letting them mix, passing water while retaining soil.
2 products
Stabilisation
A cellular system that confines fill inside its cells, arresting lateral movement and carrying the slope and the subgrade.
1 products
Protection
An open mesh that shields pipeline coating from rock impact during backfill — without blocking cathodic protection.
1 productsFeatured products.
The layers most often chosen on site.
- 9
- Product groups
- 5
- Solution families
- ASTM · EN · GRI
- Test standards
- 3
- Stages of quality control
Four sentences that define how we work.
Verify first, claim second.
Before we call a product “durable”, we know to which standard and with which test result it is durable. We never guess at a technical detail we do not know — we say so instead.
The right product is not the most expensive one.
Not every project calls for the same material. Rather than selling a customer more than they need, we recommend the solution that genuinely fits their site — the only route to long-term trust.
Transparency continues after the sale.
We state a product’s limits — which chemicals it is incompatible with, under which conditions its performance drops — before the sale; we do not create an “if only we had known” after it.
Engineering is not a one-off job.
The process runs from design through site installation to the technical support that follows. Delivering the product is the beginning of the work, not the end of it.
Start with the project, not the product.
Dams & Ponds
Membrane-faced fill dams, irrigation ponds and flood control structures.
Tunnels, Metros & Underground Structures
Underground car parks, metro stations, tunnels and diaphragm-wall tanking.
Solid Waste Landfill
Sanitary landfills, hazardous waste cells and medical waste facilities.
Mining Sites
Leach pads, tailings dams and process ponds.
Let’s talk about the real conditions on your site.
Ground, load and chemical exposure differ on every project — so does the right product. Request a project-specific quote and test report from our technical team.
Request a Quote